Below each silo with a set feeding belt conveyor, which is responsible for the silo in the aggregate to the aggregate belt. Its speed can be adjusted through the inverter, depending graded asphalt mixture may be needed. When the belt deviation phenomenon occurs, it can be corrected by adjusting the screw.
Such as when the corrugated sidewall belts deviation to the outside when the adjusting screw should pass through the outer bearing to the right will move until the belt is no longer wandering so far. And vice versa. But pay attention to the naughty tape process to grasp the principle, the belt tension should not be too small, too small belt slipping; too tight, it will cause abnormal stress roller bearings serious wear and power consumption, easy to premature failure of the belt..